Spiral bevel gears are usually made from hardened steel. The teeth of these gears are often ground for a far more precise finish allowing for little noise at high speeds. You can specify left hand or right hand based on the direction you have to run the gears

If you have a higher speed application that requires a lot of torque after that spiral bevel gears are a great option. The gears operate at 90° to one another and have “spiral” shaped tooth which provides maximum tooth surface get in touch with while rotating. With get in touch with spread over the complete tooth the spiral bevel equipment can be run much faster than the straight tooth bevel gear and handle harder starts and stops.

We make spiral bevel gears only for industrial applications.

Worm gears are found in large equipment reductions. Gear ratio ranges of 5:1 to 300:1 are usual. The setup was created so that the worm can turn the gear, but the gear cannot turn the worm. The position of the worm is usually shallow and consequently the gear is held set up because of the friction between the two. The gear is situated in applications such as for example conveyor systems where the locking feature can become a brake or an emergency stop.

The model cross-section shows a typical placement and spiral gear china utilization of a worm gear. Worm gears possess an inherent protection mechanism built-in to its style since they cannot function in the reverse direction.