SMR Gearbox Installation

SMR Gearbox Set up
Satisfactory functionality is determined by suitable set up. lubrication and maintenance. for that reason it is vital the directions from the set up and maintenance leaflet. provided with each gearbox. are followed carefully. several of the critical facets of belt and torque-arm set up are listed beneath.
one. Install pulley on gearbox input shaft as close on the reducer doable, and mount reducer on driven shaft as near to bearing as sensible. failure to do this will result in extra loads within the input shaft bearings and output bearings and could induce their premature failure.
2. Install motor and wedge belt drive with all the belt pull at somewhere around 90° on the center line involving driven and input shafts. this can allow tensioning of your wedge belt drive using the torque arm which should really preferably be in tension. if output hub runs anti-clockwise. torque arm ought to be positioned the correct.
three. lnstall torque-arm fulcrum on the rigid support so that the torque-arm will likely be at somewhere around appropriate angles to the center line through the driven shaft and the torque arm case bolt. be sure there exists adequate take up during the turnbuckle for belt stress adjustment.
Continue to keep close.
Bell drive can be positioned in any easy postion. in the event the torque arm should be to be utilised to tighten the belts, the drive need to be at about tight angle to your line between the input and output shafts.
Bell drive may very well be situated to your proper if desired.
If output hub rotates clock-wise. position belt drive and torque arm in opposite course to that shown in the illustration.
Torque arm and belt get up.
Torque arm might be mounted towards the right if desired.


Recent Posts


As one of spacer coupling manufacturers, suppliers and exporters of mechanical products, We offer spacer coupling and many other products.

Please contact us for details.

Mail: [email protected]

Manufacturer supplier exporter of spacer coupling.