Energy UNITS FOR LIFT TABLE 1
Common Description
This electrical power unit is intended exclusively for your smaller lift table,Consisting of higher stress gear pump, AC motor, multi-functional manifold, valves, tank, etc. This electrical power unit has been extensively used within the industry of logistic units like minifork lift, scissors lift and ariel functioning platforms. The lower-ing movement is managed from the solenoid valve with all the velocity controlled from the adjustable needle valve.
Energy UNITS FOR LIFT TABLE two
Standard Description
This power unit is designed solely to the medium lift table, Consisting of very effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing motion is actived through the solenoid valve plus the pace controlled by the adjustable needle valve. When the lift rises to a higher positoin, but the power supply is lower, the lowering movement is controlled by the manual override function.
Energy UNITS FOR LIFT TABLE 3
Standard Description
This electrical power unit is created exclusively to the huge lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived from the solenoid valve as well as the speed controlled by a stress compensated movement control valve.
Energy UNITS FOR LIFT TABLE four
Basic Description
This power unit is created solely for your huge lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived through the solenoid valve along with the velocity managed through the adjustable needle valve. When the lift rises to a higher positoin, but the energy provide is minimize, the lowering motion is controlled through the manual override perform.
Exclusive Notes
1. This power unit is of S3 duty cycle, which can only get the job done intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean each of the hydraulic parts concerned just before installation of the energy unit.
three. Viscosity on the oil shoud be 15~46 cst,which ought to also be clean and cost-free of impurities.N46 hydraulic oil is advisable.
four. Oil modifying is needed soon after the initial a hundred operation hrs,afterwards when just about every 3000 hrs.
five. The electrical power unit shown is intended to be mounted vertically.